LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (51 - Body Center, Roof, Frame - CARRERA (997)) >> WM 514855 Replacing Centre Side Member (Rear Section) (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster) >> Subsequent Work >> Subsequent Work For Body Repairs

Subsequent Work For Body Repairs

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Incorrect bonding of structural components with structural adhesive
  • Bonding effect not guaranteed

→ Press on joint immediately after applying adhesive. Otherwise the adhesive bead must be removed and pretreatment of the surface and application of the adhesive must be repeated.

→ Do not apply pressure to bonded parts until hardening is complete.

  1. Removing vehicle from alignment bench
  2. Cleaning spot-welded joints and sheetmetal flanges with a wire brush
  3. Priming flange areas with 2K primer
  4. Restore standard seal with body sealant

    → 5000IN SEAM SEALING

  5. Restore standard underbody protection with underbody sealant

    → WM 5000IN UNDERSEALING (ALL MODELS)

  6. Painting repair area and adjacent surfaces, if necessary
  7. Installing removed accessories in the repair area
  8. Apply cavity preservation.
scientia non olet · About LEMON Manuals