LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (51 - Body Center, Roof, Frame - CARRERA (997)) >> WM 513755 Replacing Outer Hinge Pillar (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster) >> Preparing Connection Areas Of The Body For Installing Outer Hinge Pillar >> Preparing Connection Areas Of Body For Installing Outer Hinge Pillar

Preparing Connection Areas Of Body For Installing Outer Hinge Pillar

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean undersealing, adhesive residue and paint off the body connecting flanges in the marked areas -A, B, C, D, E, F-  using a hot-air gun or rotary brush. Grind the connecting flanges until bare.
    Fig 1: Identifying Body Connecting Flanges Welding Areas
    G09822970Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Coat spot-weld flange areas with zinc powder paint.
    1. 2.1. Coat all spot-weld flange areas with zinc powder paint.
scientia non olet · About LEMON Manuals