LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (51 - Body Center, Roof, Frame - CARRERA (997)) >> WM 510555 Replacing Roof Pillar (Pipe) (All Models) >> Preparing Connection Areas Of The Body For Installing The Roof Pillar (Pipe) And Roof Frame Reinforcement >> Preparing Connection Areas Of Body For Installing Roof Pillar (Pipe)

Preparing Connection Areas Of Body For Installing Roof Pillar (Pipe)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean undersealing, adhesive residue and paint off the body connecting flanges in the marked areas -A, B, C, D-  using a hot-air gun or rotary brush. Grind the connecting flanges until bare.
    Fig 1: Identifying Body Roof Pillar Connection Areas
    G09822819Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Clean undersealing, adhesive residue and paint off the body connecting flanges in the marked areas -A-  and -B-  using a hot-air gun or rotary brush. Grind the connecting flanges until bare.
    Fig 2: Identifying Body Roof Pillar Connection Areas
    G09822820Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Coat spot-weld flange areas with zinc powder paint.
    1. 3.1. Coat all spot-weld flange areas with zinc powder paint.
scientia non olet · About LEMON Manuals