Removing Cover For Underbody - Front Section

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Underbody Cover

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Fastening nuts cannot be used again following removal.

Unscrew fastening screws -2- and fastening nuts -3- .

Fig 2: Removing Rear Cover - Front Section
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull cover for underbody -4- out of the two brake air ducts -5- at the rear and remove it.
Unscrew fastening screw -2- and remove brake air duct -5- .

Fig 3: Removing Brake Air Duct
Courtesy of PORSCHE CARS NORTH AMERICA, INC.