Installing Cover For Rear Underbody - Front Section

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cover For Rear Underbody Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

When sliding in the underbody cover, make sure the overlap is correct.

Position brake air duct -5- on the transverse strut and secure with the fastening screw -2- . → Tightening torque: 2 Nm (1.5 ft. lb.)

Fig 2: Installing Brake Air Duct
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert cover for underbody -4- and engage it at the two brake air ducts -5- at the rear.

Fig 3: Installing Rear Cover - Front Section
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws -2- . → Tightening torque: 2 Nm (1.5 ft. lb.)
Information

Fastening nuts cannot be used again following removal.
Tighten fastening nuts -3- . → Tightening torque: 2.5 Nm (2.0 ft. lb.)