Removing Windscreen Frame

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windscreen Frame Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Remove hinge pillar reinforcement at the left and right. → 516255 REPLACING HINGE PILLAR REINFORCEMENT - section on "Removing"
Milling off spotwelds
1. 2.1. Mill off spotwelds in areas -A- and -B- using a spotweld cutter.
  
  Fig 2: Cutting Spotwelds
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Milling off spotwelds
1. 3.1. Mill off spotwelds in area -A- using a spotweld cutter.
  
  Fig 3: Cutting Spotwelds
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Milling off spotwelds at the left and right
1. 4.1. Mill off spotwelds at the left and right in areas -A- and -B- using a spotweld cutter (2 plate thicknesses).
  
  Fig 4: Cutting Spotwelds (Left And Right)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Separating spotwelds at the left and right
1. 5.1. Separate spotwelds at the left and right in area -A- using a parting grinder.
  
  Fig 5: Separating Spotwelds (Left And Right)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.