Section 12 (Crank Assembly - 164 Chassis)
WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2012 Mercedes-Benz GL550, 2012 Mercedes-Benz GL450, 2011 Mercedes-Benz ML63, 2011 Mercedes-Benz ML550, and 2011 Mercedes-Benz ML350. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Testing & Repair
- Connecting rod bearing/bolts/screws - AR03.10-P-6111
- Inspect connecting rod bolts - AR03.10-P-6111-01VA
- Inspect connecting rod bolts - AR03.10-P-6111-01VT
- Tightening connecting rod screws - AR03.10-P-6111-02VA
- Tightening conrod screws - AR03.10-P-6111-02VT
- Tighten connecting rod bolts - AR03.10-P-6111-02AMG
- Install, measure conrod bearings - AR03.10-P-6111-06VA
- Installing and gauging connecting rod bearings - AR03.10-P-6111-06VT
- Mount connecting rod bearing - AR03.10-P-6111-08SX
- Piston removal and installation - AR03.10-P-7021
- Removing/installing piston rings - AR03.10-P-7311
- Remove/install balance shaft - AR03.20-P-1000GZA (ML350)
- Replace front crankshaft radial sealing ring - AR03.20-P-3000
- Replace rear crankshaft radial seal - AR03.20-P-3063
- Determine crankshaft bearing axial play - AR03.20-P-4291
- Install / gauge the crankshaft bearings - AR03.20-P-4341
- Remove/install crankshaft - AR03.20-P-4351
- Assign crankshaft bearing shells - AR03.20-P-4360
- Remove/install belt pulley/vibration damper - AR03.30-P-1600
- Remove/install retaining lock for crankshaft/ring gear - AR03.30-P-5000
- Remove/install flywheel / drive plate - AR03.30-P-8001
- Connecting rod bearing/bolts/screws - AR03.10-P-6111
- Test & Adjustment Values
- Torque Specifications