Section 54 (Controls, Housing - Manual Transmission 02Q (AWD) (Roadster))
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
- Controls, Housing
- General Information
- Description And Operation
- Selector Mechanism Overview
- Shift Knob And Covers Assembly Overview
- Shift Lever And Shift Housing For Vehicles To VIN 8J-7-013000 Assembly Overview
- Shift Lever And Shift Housing For Vehicles From VIN 8J-7-013001 Assembly Overview
- Shift Cable And Selector Cable To Model Year 2007 Assembly Overview
- Transmission Shift Lever And Selector Relay Lever To Model Year 2007 Assembly Overview
- Shift Cable And Selector Cable From Model Year 2008 Assembly Overview
- Notes
- Allocation of Control Cable Retainers
- Installing the Transmission Shift Lever
- Installation Position of Transmission Shift Lever/Selector Relay Lever
- Disconnect the Control Cable Retainer from the Shift Cable and Selector Cable
- Remove the Shift Cable from the Transmission Shift Lever and Attach
- Remove the Selector Relay Lever with Catch from the Transmission Shift Lever -arrow 1- and Attach
- Remove the Selector Relay Lever "with Clip" from the Transmission Shift Lever -arrow 1- and Attach
- Pry the Selector Cable Retainer Out of the Selector Relay Lever
- Press the Selector Cable Retainer onto the Selector Relay Lever
- Shift Mechanism, Adjusting
- SUBFRAME Mount Assembly Overview
- Transmission Overview
- Transmission Assembly Overview
- Transmission Housing And Shift Mechanism Assembly Overview
- Input Shaft, Output Shafts, Differential, Bevel Box And Selector Rods Assembly Overview
- Transmission Housing Assembly Overview
- Clutch Housing Assembly Overview
- Shift Mechanism Assembly Overview, Transmission Side
- Shift Forks Assembly Overview
- Specifications
- Removal And Installation
- Shift Knob With Shift Lever Boot
- Selector Mechanism
- Shift Cable And Selector Cable
- Transmission, Removing
- Transmission, Transporting
- Transmission, Securing To Assembly Stand
- Transmission, Installing
- Transmission Mount, Removing
- Transmission Mount, Installing
- Pendulum Support
- Bevel Box, Removing
- Bevel Box, Installing
- Input Shaft Seal
- Selector Shaft Seal
- Selector Shaft
- Disassembly And Assembly
- Selector Mechanism
- Transmission Without CIRCLIP A For Cap/Input Shaft
- Transmission With CIRCLIP A For The Cap/Input Shaft
- Shift Forks
- Transmission Housing
- Notes
- Removing Cap -A-
- Driving In Sealing Cap
- Removing Lock Elbow for Selector Shaft
- Installation Position of Lock Elbow
- Drive in the Lock Elbow for the Selector Shaft.
- Pulling Out Bearing Bushing for Selector Rod
- Driving In Bushing for Selector Rod
- Pressing Out Lock Sleeve with Transmission Disassembled
- Driving Out Lock Sleeve with Transmission Assembled
- Lock Sleeve Differentiation
- Drive In Lock Sleeve with Shoulder as Far as Stop on Tool
- Drive In Lock Sleeve without Shoulder as Far as Stop on Tool
- Pulling Needle Bearing for Reverse Shaft Out of Transmission Housing
- Press Needle Bearing into Transmission Housing
- Pulling Out Bushing for Selector Shaft
- Driving In Bushing for Selector Shaft
- Driving Out Sealing Plug
- Driving In Sealing Plug
- Clutch Housing, Servicing
- Special Tools