Transmission Mount, Removing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Support Bridge 10 - 222 A
Bracket T10338
Engine Support Basic Set T40091
Engine Support Supplement Set T40093

Removing

-- Remove the entire air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or to [For engine(s) CBRA] Removal and Installation or to [For engine(s) BPY, CDMA] Removal and Installation .

-- Remove air filter housing bracket -arrows-.

Fig 1: Air Filter Housing Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Install T10338 on open threaded hole at left rear of engine.

Fig 2: Install T10338 On Free Threaded Hold

Courtesy of AUDI OF AMERICA, LLC

-- Position 10 - 222 A with the following tool components on the upper edges of the web plate:

Fig 3: Place 10 - 222 A On Upper Edge Of Web Plates

Courtesy of AUDI OF AMERICA, LLC

Bracket for engine 10 - 222 A /1, qty. 2
Bracket with spindle and hook 10 - 222 A /10 (spindle faces toward rear)
Spindle 10 - 222 A /11 (spindle faces toward front)
Shackle 10 - 222 A /12
Connectors T40091/3, qty. 2

-- Engage 10 - 222 A /11 with 10 - 222 A /12 on right engine lifting eye.

-- Engage 10 - 222 A /10 on T10338.

-- Lightly tension the engine/transmission assembly with the spindles.

-- Install left adapter T40093/3-2 and right adapter T40093/3-3 on T40093/3.

Fig 4: Installing Engine Support Bridge Adapter

Courtesy of AUDI OF AMERICA, LLC

-- Remove ground (GND) wire from left longmember.

-- Remove left and right connecting bolt for front part of longmember.

-- Install adapters on longmembers with bolts that were removed earlier -arrow-.

NOTE:

The left side of the vehicle is shown in the illustration.

-- Insert square tube T40091/1 in connector T40091/3 and supports T40093/3 as shown in illustration.

Fig 5: Insert Square Tube As Shown In Illustration

Courtesy of AUDI OF AMERICA, LLC

-- Slide connectorT40093/4 onto square tube.

Fig 6: Slide Connector T40093/4 Onto Square Tube

Courtesy of AUDI OF AMERICA, LLC

-- Slide supports T40091/2 with slide T40093/5 into both connectors T40093/4.

WARNING:

Risk of an accident due to loose support bridge parts.

Secure T40091/2 with pins and splints from T40093/4.
Secure connector and supports with locking screws.

-- Install 10 - 222 A /11 on slide and engine lifting eye.

-- Tension the engine/transmission assembly by tightening the 3 spindles evenly.

-- Remove bolts -arrows-.

Fig 7: Identifying Bolts To Assembly Mounting On Transmission

Courtesy of AUDI OF AMERICA, LLC

-- Open wiring guide bracket -arrows-.

Fig 8: Open Wiring Router Bracket And Locating Cable Ties

Courtesy of AUDI OF AMERICA, LLC

-- Cut cable ties -1- and press electrical wires to side.

-- Unclip wiring guide.

-- Remove bolts -1- and remove transmission mount -A-.

Fig 9: Transmission Mount And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove 10 - 222 A from engine.

Install the transmission mount. Refer to TRANSMISSION MOUNT, INSTALLING .