Transmission Mount, Installing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Installing

Tightening specifications, refer to SUBFRAME MOUNT ASSEMBLY OVERVIEW .

Install in reverse order, paying attention to the following:

-- First install transmission bracket on transmission -arrows-.

Fig 1: Removing/Installing Console From Transmission

Courtesy of AUDI OF AMERICA, LLC

-- Raise transmission with engine support bridge10 - 222 A spindle until transmission bracket -1- touches transmission mount support arm -2-.

Fig 2: Aligning Engine/Transmission In Installed Location

Courtesy of AUDI OF AMERICA, LLC

-- Next install bolts -arrows- but only tighten by hand.

CAUTION:

Risk of damaging threads in transmission mount support arm due to bolts inserted crooked.

Before installing bolts -arrows-, transmission bracket -1- and transmission mount support arm -2- must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.

-- Only tighten bolts if subframe is installed. Refer to Removal and Installation and subframe mounts are adjusted [For engine(s) CETA, CCTA] Description and Operation or to [For engine(s) CDMA] Description and Operation or to [For engine(s) CBRA] Description and Operation or to [For engine(s) BPY] Description and Operation .

-- Remove 10 - 222 A from engine.

-- Install the air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or to [For engine(s) CBRA] Removal and Installation or to [For engine(s) BPY, CDMA] Removal and Installation .