Gear Oil In Bevel Box, Checking

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Bevel box is installed to the side of manual transmission and has a separate self-contained oil system.

Special tools and workshop equipment required

Used Oil Collecting and Extracting Device V.A.G 1782

Procedure

Vehicle must be level
Bevel box must be in installation location.
Tightening specification, refer to BEVEL BOX OIL FILLER BOLT .

-- Remove noise insulation in center by loosening fasteners -1 through 4-.

Fig 1: Center Noise Insulation Fasteners And Center Noise Insulation Panel

Courtesy of AUDI OF AMERICA, LLC

-- Place the V.A.G 1782 under the bevel box.

-- Remove oil filler bolt -arrow- in bevel box.

Fig 2: Identifying Oil Filler Bolt In Bevel Box

Courtesy of AUDI OF AMERICA, LLC

Target value: the fluid level must reach the lower edge of the oil filler hole.

-- Add gear oil if necessary. Refer to GEAR OIL IN BEVEL BOX, FILLING .

NOTE:

Carefully remove leaking oil on bevel box.

-- Tighten the new oil filler bolt. Tightening specification, refer to OIL FILLER BOLT - TIGHTENING SPECIFICATION

-- Install the noise insulation. Refer to Removal and Installation .