Shift Cable And Selector Cable To Model Year 2007 Assembly Overview: Notes

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Grease bearing areas and slide surfaces with grease G 000 450 02.

Fig 1: Shift Cable And Selector Cable To Model Year 2007 Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Retaining Washer
Control Cable Retainer
- For the selector cable on the selector relay lever
- Allocation, refer to ALLOCATION OF CONTROL CABLE RETAINERS
- Release to adjust selector mechanism, refer to RELEASE CABLE RETAINER -A- FOR SELECTOR AND SHIFT CABLES -B- AS FOLLOWS
Retaining Washer
Control Cable Retainer
- For shift cable to transmission shift lever
- Allocation, refer to ALLOCATION OF CONTROL CABLE RETAINERS
- Release to adjust selector mechanism, refer to RELEASE CABLE RETAINER -A- FOR SELECTOR AND SHIFT CABLES -B- AS FOLLOWS
Bushing
Grommet
Shift Cable
- Removing and installing, refer to SHIFT CABLE AND SELECTOR CABLE
- From VIN 8J-7-013001, modified attachment to the shift lever within the shift mechanism -8-, refer to item 8
- Adjusting, refer to SHIFT MECHANISM, ADJUSTING
Lock Washers
- No longer used from VIN 8J-7-013001, refer to SHIFT LEVER AND SHIFT HOUSING FOR VEHICLES FROM VIN 8J-7-013001 ASSEMBLY OVERVIEW
Circlips
Selector Cable
- Removing and installing, refer to SHIFT CABLE AND SELECTOR CABLE
- From VIN 8J-7-013001, modified attachment to the selector bracket within the shift mechanism -6-, refer to item 6
- Adjusting, refer to SHIFT MECHANISM, ADJUSTING
Bolt
- 20 Nm
- Quantity 3
Control Cable Mounting Bracket
Nut
- Only in vehicles with a 4-cylinder engine