Shift Mechanism, Adjusting: Adjusting
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
-- Open the ashtray.
-- Carefully pry trim from center console -arrows-.
-- Lift trim up over shift knob.
-- Move the shift lever in the neutral position toward the left into the 1st/2nd gear shift gate.
-- Lift the noise insulation plate.
-- Guide the T10027A through hole -A- and into hole -B-.
NOTE:
To improve clarity, the noise insulation is removed in the figure.
-- Completely remove the air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or to [For engine(s) CBRA] Removal and Installation or to [For engine(s) BPY, CDMA] Removal and Installation .