LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> TT S, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Controls, Housing - Manual Transmission 02Q (AWD) (Roadster)) >> Controls, Housing >> Description And Operation >> Input Shaft, Output Shafts, Differential, Bevel Box And Selector Rods Assembly Overview >> Notes

Input Shaft, Output Shafts, Differential, Bevel Box And Selector Rods Assembly Overview: Notes

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Input Shaft, Output Shafts (Pinion Shafts), Differential, Bevel Box And Selector Rods
GWWA34-10039Courtesy of AUDI OF AMERICA, LLC
  1. Output Shaft, 1st to 4th Gears
  2. Selector Rod with Shift Fork for 1st and 2nd Gear
  3. Selector Rod with Shift Fork for 3rd and 4th Gear
  4. Output Shaft 5th/6th Gear/Reverse Gear
  5. Selector Rod with Shift Fork for 5th and 6th Gear
  6. Reverse Gear Shift Fork
  7. Input Shaft
  8. Reverse Shaft
    • With thrust washer
  9. Thrust Washer
  10. Bleeder
    • Connect to clutch slave cylinder, refer to item  14
  11. Clutch Housing
  12. Input Shaft Seal
  13. O-ring
    • Always replace
    • Pull onto line connection
    • Coat with brake fluid before installing
  14. Clutch Slave Cylinder with Release Bearing
  15. Bolt
  16. Bolt
  17. Bolt
    • Replace
    • 40 Nm
    • Quantity: 4
  18. Bevel Box
  19. Differential
scientia non olet · About LEMON Manuals