Shift lever adjustment, checking

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

The shift lever must be in the 3rd/4th gear shift gate when the transmission is in neutral.

-- Actuate clutch.

-- Select all gears several times. Pay particular attention to the operation of the reverse gear lock

The shift lever must move automatically from the reverse gear shift gate into the 3rd/4th gear shift gate.

If hooking occurs during repeated selection of a gear, the selector mechanism must be adjusted again.

-- Install the center console cover and trim.

-- Install the air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or to [For engine(s) CBRA] Removal and Installation or to [For engine(s) BPY, CDMA] Removal and Installation .