Section 3 (Engine Overhaul - 2.0L Turbo - Lancer)
WARNING: This page is about a different variant/trim than selected.
- General Specifications
- Service Specifications
- Fastener Tightening Specifications
- Sealants And Adhesives
- Special Tools
- Generator And Ignition System
- Throttle Body
- Intake Manifold And Fuel System
- Removal And Installation
- Notes
- Installation Service Points
- >> A << Engine Oil Pressure Switch Installation
- >> B << Knock Sensor Installation
- >> C << Intake Manifold Stay Installation
- >> D << O-Ring Installation
- >> E << Injector/O-Ring/Injector Support Installation
- >> F << Fuel Rail Assembly Installation
- >> G << Fuel Pressure Regulator Installation
- >> H << Fuel Return Pipe Installation
- Removal And Installation
- Exhaust Manifold
- Water Hose And Pipe
- Oil Pan And Timing Chain Case
- Timing Chain
- Camshaft
- Cylinder Head And Valves
- Oil Pump Chain
- Piston And Connecting Rod
- Crankshaft And Cylinder Block