LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Overhaul - 2.0L Turbo - Lancer) >> Intake Manifold And Fuel System >> Removal And Installation >> Installation Service Points >> >> A << Engine Oil Pressure Switch Installation

>> A << Engine Oil Pressure Switch Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not allow sealant to squeeze out to the screw tip.
  • Do not exceed the specified torque.
  1. Completely remove sealant adhering to the engine oil pressure switch and cylinder block threaded holes.
  2. Apply sealant (Three bond 1215, Three bond 1212D or equivalent) of 5 mm (0.2 inch) to the threaded portion of the engine oil pressure switch shown in the illustration.
  3. Tighten the engine oil pressure switch to the cylinder block to the specified torque.

    Specified torque: 10 ± 2 N.m (89 ± 17 in-lb) 

    Fig 1: Identifying Engine Oil Pressure Switch Sealant Application Area
    G05425842Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals