>> B << Exhaust V.V.T. Sprocket Bolt Installation
WARNING: This page is about a different variant/trim than selected.
- Assemble the exhaust V.V.T. sprocket assembly in the following procedure.
- Make sure that the knock pin of the exhaust camshaft assembly is positioned facing straight upward.
- Apply an appropriate and minimum amount of engine oil to the circumference of the tip of the exhaust V.V.T. sprocket assembly and the entire circumference of the area into which the exhaust V.V.T. sprocket assembly is inserted.
- Slowly insert the exhaust V.V.T. sprocket assembly into the normal position of the exhaust camshaft assembly with its knock pin hole facing straight upward.
- Install the V.V.T. sprocket.
- Make sure that the V.V.T. sprocket is securely inserted into the bottom and that the V.V.T. sprocket does not rotate with the hexagonal portion of the camshaft secured with a wrench.
- Hold the hexagonal portion of the camshaft with a wrench and tighten the camshaft sprocket bolt to the specified torque.
Specified torque: 85 ± 5 N.m (63 ± 3 ft-lb)