LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Overhaul - 2.0L Turbo - Lancer) >> Exhaust Manifold >> Removal And Installation >> Installation Service Points >> >> F << Exhaust Fitting Bracket Installation

>> F << Exhaust Fitting Bracket Installation

WARNING: This page is about a different variant/trim than selected.
  1. After temporarily tightening the exhaust fitting bracket with the installation bolts, check the exhaust manifold fastens securely to the cylinder block and the exhaust fitting.
  2. Tighten the cylinder block side bolt to the specified tightening torque.

    Specified torque: 51 ± 7 N.m (38 ± 4 ft-lb) 

  3. Tighten the exhaust fitting bracket side bolt to the specified tightening torque.

    Specified torque: 64 ± 5 N.m (47 ± 3 ft-lb) 

    Fig 1: Identifying Exhaust Fitting Bracket And Cylinder Block
    G05902116Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals