LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Overhaul - 2.0L Turbo - Lancer) >> Oil Pan And Timing Chain Case >> Removal And Installation >> Installation Service Points >> >> D << Cylinder Head Cover Installation

>> D << Cylinder Head Cover Installation

WARNING: This page is about a different variant/trim than selected.
  1. Completely remove liquid gasket adhering to the cylinder head cover, timing chain case and cylinder head.
  2. Degrease the cylinder head cover, timing chain case and cylinder head.
    CAUTION: Install the cylinder head cover immediately after liquid gasket is applied.
  3. Appropriately use a minimum amount of sealant. Be careful not to allow sealant to squeeze out from the application area.

    Apply liquid gasket (Three bond 1217G [Mitsubishi Motors Genuine Part No.1000A923] or exact equivalent) of 4.0 mm (0.16 inch) of thickness in diameter.

    Fig 1: Identifying Timing Chain Case Assembly Liquid Gasket Application Area
    G07046104Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Tighten the cylinder head cover to the tightening torque of 3.0 ± 1.0 N.m (27 ± 8 in-lb) in the order shown in the illustration.
  5. Then, tighten it to the specified torque in the same order.

    Specified torque: 5.5 ± 0.5 N.m (49 ± 4 in-lb) 

    Fig 2: Cylinder Head Cover Bolt Tightening Sequence
    G05374012Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals