<< A >> Timing Chain TENSIONER Removal

WARNING: This page is about a different variant/trim than selected.

Insert a flatblade screwdriver into the release hole of the timing chain tensioner to release the latch.
Push the tensioner lever by hand and push in the plunger of the timing chain tensioner until it hits the bottom. Then, insert a hard wire (piano wire or the like) of ø1.5 or hexagonal bar wrench (1.5 mm [0.05 inch]) into the fixing hole of the plunger.
Remove the timing chain tensioner.

Fig 1: Identifying Ratchet Release Hole, Plunger Fixed Hole And Wire
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.