>> E << Flywheel Bolt Installation

WARNING: This page is about a different variant/trim than selected.

Clean off sealant and oil of thread of crankshaft and flywheel bolt.
Use special tool MB991883 to secure the flywheel.

Fig 1: Securing Flywheel Using Special Tool MB991883
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply engine oil to thread of crankshaft and bolt seat area of flywheel.
Apply the sealant (Three bond 1324 or equivalent) to the thread of flywheel bolt.

Fig 2: Identifying Flywheel Bolt Sealant Application Area
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tighten flywheel bolts to temporary torque 40 N.m (30 ft-lb) in the order shown to illustration.
Tighten flywheel bolts to specified torque in the order shown in the illustration.
Specified torque: 130 N.m (96 ft-lb)

Fig 3: Flywheel Bolt Tightening Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.