LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Overhaul - 2.0L Turbo - Lancer) >> Oil Pump Chain >> Removal And Installation >> Installation Service Points >> >> B << Crankshaft Sprocket Installation

>> B << Crankshaft Sprocket Installation

WARNING: This page is about a different variant/trim than selected.
  1. Wipe off the dirt on the crankshaft sprocket and the crankshaft using a rag, and then remove the grease from the portion shown in the illustration.
    NOTE: Remove grease to prevent a drop in the coefficient of friction of the pressing portion caused by adhesion of oil.
  2. Set the No. 1 piston at top dead center on the compression stroke.
  3. Install the crankshaft sprocket to the crankshaft.
    Fig 1: Identifying Grease Portion Of Crankshaft Sprocket And Crankshaft
    G05374336Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals