LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Overhaul - 2.0L Turbo - Lancer) >> Exhaust Manifold >> Removal And Installation >> Installation Service Points >> >> D << Turbocharger Bracket Installation

>> D << Turbocharger Bracket Installation

WARNING: This page is about a different variant/trim than selected.
  1. After temporarily tightening the turbocharger bracket with the installation bolts, check the exhaust manifold fastens securely to the cylinder block and the turbocharger.
  2. Tighten the cylinder block side bolt to the specified tightening torque.

    Specified torque: 51 ± 7 N.m (38 ± 4 ft-lb) 

  3. Tighten the turbocharger side bolt to the specified tightening torque.

    Specified torque: 64 ± 5 N.m (47 ± 3 ft-lb) 

    Fig 1: Identifying Turbocharger, Bracket And Cylinder Block
    G05902114Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals