Section 122 (Exterior Body Panels)
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Balance Spring Removal/Installation
- Body Panels Location Index
- Bumper Slider Removal/Installation
- Bumper Stiffener Lower Removal/Installation
- Cowl Panel Removal/Installation
- Energy-Absorbing Form Removal/Installation
- Front Bumper Disassembly/Assembly
- Front Bumper Installation
- Front Bumper Reinforcement Removal/Installation
- Front Bumper Removal
- FRONT FENDER INSULATOR No. 1 REMOVAL/INSTALLATION
- FRONT FENDER INSULATOR No. 2 INSTALLATION
- FRONT FENDER INSULATOR No. 2 REMOVAL
- Front Fender Panel Removal/Installation
- Front Fender Stay Removal/Installation
- Fuel-Filler Lid Adjustment
- Fuel-Filler Lid Removal/Installation
- Hood Adjustment
- Hood Disassembly/Assembly
- Hood Removal/Installation
- Intake Air Guide Removal/Installation
- Rear Bumper Disassembly/Assembly
- Rear Bumper Reinforcement Removal/Installation
- Rear Bumper Removal/Installation
- Seal Plate Removal/Installation
- Set Plate Removal/Installation
- Shroud Panel Removal/Installation
- Shroud Upper Member Removal/Installation
- Trunk Lid Adjustment
- Trunk Lid Removal/Installation