LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Exterior Body Panels) >> FRONT FENDER INSULATOR No. 2 REMOVAL

FRONT FENDER INSULATOR No. 2 REMOVAL

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife.
  1. Remove the front mudguard. (See MUDGUARD REMOVAL/INSTALLATION .)
  2. Cut off the double-sided adhesive tape in the position shown in the figure using a utility knife and remove front fender insulator No. 2 from the body.
Fig 1: Removing Front Fender Insulator No. 2 From Body
G11447570Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals