Section 12 (Rear Wheel Suspension, Axle Shaft)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening torques for rear axle
- Removing and installing rear spring strut
- Disassembling and assembling rear spring strut
- Removing and installing diagonal brace
- Removing and installing cable
- Removing and installing rear wheel bearing
- Removing and installing rear tie rod (toe control arm)
- Removing and installing drive shaft
- Fitting the drive shaft to the transmission: combinations permitted for the Boxster
- Removing and installing rear axle strut (control arm)
- Removing and installing rear stabilizer
- Removing and installing the rear-axle cross member
- Removing and installing sheetmetal brace