LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Rear Wheel Suspension, Axle Shaft) >> Removing and installing rear axle strut (control arm) >> Installation

Removing and installing rear axle strut (control arm): Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install in reverse order. Before installing, give all parts a visual check. Replace fastening nuts. Use correct tightening torques.
  2. When installing the axle strut, make sure that the axle strut is tightened only in vehicle position. Vehicle position means: vehicle standing on its wheels.
  3. Carry out suspension alignment.
scientia non olet · About LEMON Manuals