Section 5 (Engine Cooling System (VIN A))
WARNING: This page is about a different variant/trim than selected.
- Coolant Reserve Tank Removal/Installation [PYUL]
- D-code
- Open Capsule Cover
- Remove Cooling System Cap (Sub) (PYUL)
- Remove Cooling System Cap
- Drain Engine Coolant (Main)
- Drain EV System Coolant
- Remove Engine Coolant Reserve Tank
- Install in Reverse Order of Removal
- Add Engine Coolant (Main)
- Perform Engine Coolant (Main) Air Bleeding (With e-SKYACTIV PHEV)
- Bleed Coolant (Sub) Air (With e-SKYACTIV PHEV)
- Inspect For Engine Coolant Leakage
- Install cooling system cap (sub)
- Install cooling system cap
- Coolant Switching Valve (CSV) Inspection [PYUL]
- Coolant Switching Valve (CSV) Removal/Installation [001]
- D-code
- Perform Viewing Information Verification
- Open Capsule Cover
- Remove Cover Assembly (Passenger's Side)
- Disconnect Negative Lead-Acid Battery Terminal
- Remove Cooling System Cap
- Remove Front Under Cover No. 2
- Remove Front Under Cover No. 1
- Drain Engine Coolant (Main)
- Remove Coolant Switching Valve No. 1
- Install in Reverse Order of Removal
- Add Engine Coolant (Main)
- Install cooling system cap
- Perform Engine Coolant (Main) Air Bleeding (With e-SKYACTIV PHEV)
- Inspect For Engine Coolant Leakage
- Perform Power Liftgate Initialization
- Initialize Power Outer Mirror Retract/Return Function
- Coolant Switching Valve (CSV) Removal/Installation [002]
- D-code
- Perform Viewing Information Verification
- Open Capsule Cover
- Remove Cover Assembly (Passenger's Side)
- Disconnect Negative Lead-Acid Battery Terminal
- Remove Cooling System Cap (Sub) (PYUL)
- Remove Front Under Cover No. 2
- Remove Front Under Cover No. 1
- Drain EV System Coolant
- Remove Driver Side Front Over Fender Lower
- Remove Driver Side Front Over Fender Upper
- Remove Driver Side Front Mudguard
- Remove Coolant Switching Valve No. 2
- Install in Reverse Order of Removal
- Add Coolant (Sub) [PYUL] (With e-SKYACTIV PHEV)
- Install cooling system cap (sub)
- Bleed Coolant (Sub) Air (With e-SKYACTIV PHEV)
- Inspect For PHEV Coolant Leakage
- Perform Power Liftgate Initialization
- Initialize Power Outer Mirror Retract/Return Function
- Coolant Switching Valve (CSV) Removal/Installation [PYUL]
- Cooling Fan Motor Inspection [PYUL]
- Cooling Fan Motor Removal/Installation [PYUL]
- D-code
- Open Capsule Cover
- Remove Cover Assembly (Passenger's Side)
- Disconnect Negative Lead-Acid Battery Terminal
- Remove Air Cleaner Component
- Remove Front Under Cover No. 2
- Remove Front Under Cover No. 1
- Remove Front Tires (RH)
- Remove Passenger Side Front Mudguard
- Remove Cooling Fan Motor
- Install in Reverse Order of Removal
- Perform Power Liftgate Initialization
- Initialize Power Outer Mirror Retract/Return Function
- Cooling System Cap Inspection [PYUL]
- Cooling System Location Index [PYUL]
- Cooling System Service Warnings [PYUL]
- ELECTRIC WATER PUMP No. 1 INSPECTION [PYUL]
- ELECTRIC WATER PUMP No. 1 REMOVAL/INSTALLATION [PYUL]
- D-code
- Open Capsule Cover
- Remove Cover Assembly (Passenger's Side)
- Disconnect Negative Lead-Acid Battery Terminal
- Remove Front Under Cover No. 2
- Remove Front Under Cover No. 1
- Drain EV System Coolant
- Remove Driver Side Front Deflector
- Remove Electric Water Pump No. 1
- Install in Reverse Order of Removal
- Add Coolant (Sub) [PYUL] (With e-SKYACTIV PHEV)
- Bleed Coolant (Sub) Air (With e-SKYACTIV PHEV)
- Inspect For PHEV Coolant Leakage
- Install cooling system cap (sub)
- Perform Power Liftgate Initialization
- Initialize Power Outer Mirror Retract/Return Function
- Engine Coolant Concentration Inspection [PYUL]
- Engine Coolant Leakage Inspection [PYUL]
- Engine Coolant Level Inspection [PYUL]
- Engine Coolant Replacement [PYUL]
- Fan Control Module Inspection [PYUL]
- Radiator Removal/Installation [PYUL]
- D-code
- Open Capsule Cover
- Remove Cover Assembly (Passenger's Side)
- Disconnect Negative Lead-Acid Battery Terminal
- Remove Cooling System Cap (Sub) (PYUL)
- Remove Cooling System Cap
- Drain Engine Coolant (Main)
- Drain EV System Coolant
- Remove Air Cleaner Component
- Remove Passenger Side Edge Rubber
- Remove Driver Side Edge Rubber
- Remove Latch Cover Component
- Remove the front bumper component
- Remove Center Seal Plate
- Remove Bracket
- Remove Intake Air Guide (Upper)
- Remove Passenger's Side Seal Plate
- Remove Driver's Side Seal Plate
- Remove Radiator Mount (LH)
- Remove Radiator Mount (RH)
- Remove Shroud Upper Member
- Remove Intake Air Guide (Lower)
- Remove Active Air Shutter
- Remove Cooling Fan Motor
- Remove Radiator
- Install in Reverse Order of Removal
- Add Engine Coolant (Main)
- Add Coolant (Sub) [PYUL] (With e-SKYACTIV PHEV)
- Perform Engine Coolant (Main) Air Bleeding (With e-SKYACTIV PHEV)
- Bleed Coolant (Sub) Air (With e-SKYACTIV PHEV)
- Inspect For Engine Coolant Leakage
- Perform 360° View Monitor System Aiming
- Perform Radar Sensor (Front) Aiming (Without Radar Sensor (Front Side))
- Simultaneously Aim Radar Sensor (Front) And (Front Side) (With Radar Sensor (Front Side))
- Perform Power Liftgate Initialization
- Initialize Power Outer Mirror Retract/Return Function
- Thermostat Inspection [PYUL]
- Thermostat Removal/Installation [PYUL]
- D-code
- Open Capsule Cover
- Remove Front Under Cover No. 2
- Remove Front Under Cover No. 1
- Drain Engine Coolant (Main)
- Remove Engine Wall
- Remove Water Outlet
- Remove Thermostat
- Install in Reverse Order of Removal
- Add Engine Coolant (Main)
- Remove Cooling System Cap
- Perform Engine Coolant (Main) Air Bleeding (With e-SKYACTIV PHEV)
- Inspect For Engine Coolant Leakage
- Install cooling system cap
- Water Pump Removal/Installation [PYUL]
- D-code
- Open Capsule Cover
- Remove Front Under Cover No. 2
- Remove Front Under Cover No. 1
- Drain Engine Coolant (Main)
- Remove Water Pump Drive Belt
- Water pump pulley removal
- Remove Water Pump
- Install in Reverse Order of Removal
- Add Engine Coolant (Main)
- Perform Engine Coolant (Main) Air Bleeding (With e-SKYACTIV PHEV)
- Remove Cooling System Cap
- Inspect For Engine Coolant Leakage
- Install cooling system cap