DTC inspection (coolant switching valve No. 2)
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Connect the M-MDS to the DLC-2 and perform the procedure.
- Using the M-MDS, perform a DTC inspection and verify if any coolant switching valve No. 2-related DTCs are detected. (Refer to [DTC INSPECTION
] in the appropriate troubleshooting information
)
DTC is detected
- Inspect the possible causes of the detected DTCs starting from the top. (Refer to [DTC TABLE [ECM (E-SKYACTIV PHEV)]
] in the appropriate troubleshooting information
)
- If the malfunction has not been resolved, replace coolant switching valve No. 2. (See COOLANT SWITCHING VALVE (CSV) REMOVAL/INSTALLATION [002] ).
No DTC is detected
- Perform a visual inspection. (See VISUAL INSPECTION (COOLANT SWITCHING VALVE NO. 2) )
- Inspect the possible causes of the detected DTCs starting from the top. (Refer to [DTC TABLE [ECM (E-SKYACTIV PHEV)]
] in the appropriate troubleshooting information
)