DTC inspection
WARNING: This page is about a different variant/trim than selected.
- Perform a DTC inspection using the M-MDS to verify if any electric water pump No. 1-related DTCs are detected. (Refer to [DTC INSPECTION
] in the appropriate troubleshooting information
)
DTC is detected
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [PCM]
] in the appropriate troubleshooting information
)
- If the malfunction is not resolved, replace the electric water pump No. 1.
No DTC is detected
- Perform a visual inspection. (See VISUAL INSPECTION )
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [PCM]
] in the appropriate troubleshooting information
)