Body, General Information - 911 CARRERA (996)

• Safety notes
  • Safety instructions for raising vehicles
    • Danger of injury when raising vehicles
    • Damage when raising vehicles
  • Safety instructions for welding
    • Dangers of injury when welding
    • Safety instructions for flying sparks during grinding and welding work
    • Safety instructions for fuel tank
    • Safety instructions for air conditioning
  • Safety instructions for sticking
  • Safety instructions for installation work
    • Safety instructions for sharp-edged body and unit parts
    • Safety instructions for airbag system
    • Safety instructions for door
  • Safety instructions for corrosion protection
    • Safety instructions for plug location plan (body)
    • Safety instructions for water drains (body)
• General information and quality notes
  • Measures for maintaining long-term body protection
    • Notes
    • Prerequisite for maintaining the long-life guarantee
  • Electronic control units
    • Notes
    • Protection against overvoltage
    • Replacing control modules
• Tools and metalworking tools for body repairs
  • Straightening systems
  • Metalworking tools
• Check dimensions for body repair
  • Floor assembly control dimensions for the 996 Carrera model up to model year 2000
  • Floor assembly control dimensions for the 996 Carrera model from model year 2001
• Notes on repairs to 911 Carrera 4S (996)
• Body parts of high-strength steel
  • Notes
  • High-strength steel plates
  • Tailored blanks
  • Baked Hardening
  • Straightening body parts
  • Welding work
  • Reshaping
  • Separation points
• Water drainage plan
• Water drainage plan - Cabriolet
• Water drainage plan - Targa
• Check dimensions for body repair - Cabriolet structure
  • Notes
  • Structure dimensions for cabriolet
• Plug location plan
  • Notes
  • Top of front of vehicle
  • Bottom of front of vehicle
  • Side of front of vehicle
  • Bottom of lower side member and floor
  • Top of lower side member and floor
  • Bottom of rear end
  • Top of rear end
  • Side of rear end
• Undersealing
  • Notes
  • Bottom of front of vehicle, layout plan
  • Bottom of lower side member and floor, layout plan
  • Bottom of rear end, layout plan
  • Tools and materials
• Diagram - body gap dimensions
  • Notes
  • Diagram - body gap dimensions up to model year 2001
    • Gap dimensions, body front
    • Gap dimensions, body centre
    • Gap dimensions, body rear
  • Diagram - body gap dimensions as of model year 2002
    • Gap dimensions, body front
    • Gap dimensions, body centre
    • Gap dimensions, body rear
  • Diagram - Gap dimensions, Carbiolet
    • Diagram - Centre gap dimensions, Cabriolet
    • Diagram - Gap dimensions, rear Cabriolet
    • Diagram - Gap dimensions, hardtop
  • Diagram - body gap dimensions - Targa
    • Gap dimensions, body centre
    • Gap dimensions, body rear
• Diagram - keys to symbols for welding work
  • Resistance spot welding
  • Inert-gas arc welding (MAG procedure)
  • Gas welding
• Seam seals
  • Notes
  • Accessories
• Work sequence for accident repair
• Work sequence for determining scope of damage vehicles involved in an accident
• Vehicle identification number
  • Notes
  • Imprinting new vehicle identification number
• Check dimensions for body diagnosis (repairs) - Targa
  • Notes
  • Check dimensions for the interior construction
  • Check dimensions for the exterior construction
• Diagram - Body, model year 2002
  • Notes
  • Structural body parts (model care) for model year 2002