Section 47 (Headlight System - With Diagnostics - Lancer)
WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Service Specifications
- Special Tools
- Service Precautions (Discharge Headlight)
- Diagnosis
- Diagnostic Trouble Code Procedures
- DTC B16A2: Blown turn-signal light (LH) bulb
- DTC B16A3: Turn-signal light (LH) short circuit
- DTC B16A4: Blown turn-signal light (RH) bulb
- DTC B16A5: Turn-signal light (RH) short circuit
- DTC L0432: RLS RS Adaptation Error
- DTC L0434: RLS Light Sensor Error; DTC L0436: RLS Rain Sensor Error
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: None of headlights (low-beam) illuminates
- Inspection Procedure 2: None of headlights (high-beam) illuminates
- Inspection Procedure 3: The headlights illuminate at low-beam (high-beam does not illuminate) regardless of the lighting switch positions
- Inspection Procedure 4: Headlights do not illuminate when the passing switch is operated
- Inspection Procedure 5: One of the headlight(s) does not illuminate
- Inspection Procedure 6: High-beam indicator light does not illuminate normally
- Inspection Procedure 7: The headlight automatic shutdown function does not work normally
- Inspection Procedure 8: Daytime running light function does not work normally. < Halogen type headlight >
- Inspection Procedure 8: Daytime running light function does not work normally. < Discharge type headlight >
- Inspection Procedure 9: One of the position light, the taillight, the rear side marker lights or the license plate light does not illuminate
- Inspection Procedure 10: The auto light function does not work normally
- Inspection Procedure 11: None of turn-signal lights illuminates
- Inspection Procedure 12: The comfort flashing function does not work normally
- Inspection Procedure 13: The turn-signal indicator lights do not illuminate
- Inspection Procedure 14: The welcome light function does not work normally
- Inspection Procedure 15: The coming home light function does not work normally
- Data List Reference Table
- On-Vehicle Service
- Headlight Aiming
- Luminous Intensity Measurement
- Replace The Bulb
- Headlight Automatic-Shutdown Function Check
- Headlight Auto Light Function Check
- Welcome Light Function Check
- Coming-Home Light Function Check
- Customization Function
- Headlight Removal And Installation
- Headlight Leveling Switch Removal And Installation
- Lighting Control Sensor Removal And Installation
- Inspection