LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2017 >> Lancer SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Headlight System - With Diagnostics - Lancer) >> Service Precautions (Discharge Headlight) >> Checking Procedure For Discharge Headlight Related Parts (Inspection Procedure When Reusing The Controller) >> 1 - 2 Check Of Wiring Harness Between Controller And Bulb

1 - 2 Check Of Wiring Harness Between Controller And Bulb

WARNING: This page is about a different car, the 2015 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

If any of the check items below are found, replace the wiring harness between the controller and the bulb.

WARNING: If the wiring harness between the controller and the bulb is damaged, always replace it. Attempting to repair the wiring harness may cause a melted harness wire, or may result in a burn or death due to an electric shock by high voltage.
Items to be checked Why the controller should be replaced
Wiring harness shield damaged Abnormal noise may cause.
Damaged connector (chipped or cracked plastics, or deformed terminal) The damaged part(s) may cause poor connection or short circuit.
scientia non olet · About LEMON Manuals