Section 4 (Engine Overhaul - 2.4L - Lancer)
WARNING: This page is about a different variant/trim than selected.
- General Specifications
- Service Specifications
- Rework Dimensions
- Torque Specifications
- Sealants
- Special Tools
- Generator And Ignition System
- Throttle Body And EGR System
- Intake Manifold And Fuel System
- Removal And Installation
- Notes
- Installation Service Points
- >> A << Engine Oil Pressure Switch Installation
- >> B << Generator Bracket Installation
- >> C << Intake Manifold Installation
- >> D << Inlet Manifold Stay Installation
- >> E << O-Ring Installation
- >> F << Injector And Injector Support Installation
- >> G << Fuel Rail Assembly/Bracket/Injector Protector Rear Installation
- Removal And Installation
- Exhaust Manifold
- Water Hose And Pipe
- Oil Pan And Timing Chain Case
- Timing Chain
- Camshaft
- Cylinder Head And Valves
- Balancer Chain
- Piston And Connecting Rod
- Removal And Installation
- Notes
- Removal Service Points
- Installation Service Points
- >> A << Piston Pin Installation
- >> B << Oil Ring Installation
- >> C << Piston Ring Number. 2/Piston Ring Number. 1 Installation
- >> D << Piston Connecting Rod Assembly Installation
- >> E << Connecting Rod Bearing Installation
- >> F << Connecting Rod Cap Installation
- >> G << Connecting Rod Cap Bolt Installation
- Inspection
- Removal And Installation
- Crankshaft And Cylinder Block