>> C << O-Ring/Engine Oil Control Valve Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- The O-ring must not be reused.
- Wind non-adhesive tape (seal tape, etc.) around the notch of the oil passage of the oil feeder control valve before installing the O-ring to prevent damage. Damage to the O-ring causes oil leakage.
- Apply a small amount of engine oil to the O-ring of the oil feeder control valve.
- Install the oil feeder control valve on the cylinder head.
- Tighten the oil feeder control valve to the specified tightening torque of 10 ± 2 N.m (89 ± 17 in-lb).