LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Overhaul - 2.4L - Lancer) >> Intake Manifold And Fuel System >> Removal And Installation >> Installation Service Points >> >> A << Engine Oil Pressure Switch Installation

>> A << Engine Oil Pressure Switch Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not allow sealant to squeeze out to the screw tip.
  • Do not tighten, exceeding the specified tightening torque.
  1. Completely remove sealant adhering to the oil pressure switch and cylinder block threaded holes.
  2. Apply sealant of 5 mm to the threaded portion of the oil pressure switch shown in the illustration.

    Specified sealant: 

    Three bond 1212D, Three bond 1215 or equivalent 

    Fig 1: Identifying Sealant Applying Area Adhering To Oil Pressure Switch And Cylinder Block Threaded Holes
    G05425842Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Tighten the oil pressure switch to the cylinder block to the specified tightening torque.

    Tightening torque: 10 ± 2 N.m (89 ± 17 in-lb) 

scientia non olet · About LEMON Manuals