>> C << Exhaust Manifold Bracket Installation

WARNING: This page is about a different variant/trim than selected.

Make sure that exhaust manifold bracket A is in intimate contact with the exhaust manifold and cylinder block, and then tighten it to the specified tightening torque.

Tightening torque:

M10: 41 ± 10 N.m (30 ± 7 ft-lb)

M8: 20 ± 5 N.m (15 ± 3 ft-lb)

Fig 1: Identifying Exhaust Manifold Bracket (FWD)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Exhaust Manifold Bracket (AWD)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.