<< C >> Ladder Frame Removal

WARNING: This page is about a different variant/trim than selected.

Pry the illustrated position with a screwdriver or tap the boss with a hammer.

Fig 1: Ladder Frame Prying Position Using Screwdriver
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If the ladder frame does not come off, insert a flatblade screwdriver into the gap between the ladder frame and bearing cap as shown in the illustration and lightly pry it to remove the ladder frame.

Fig 2: Inserting Flatblade Screwdriver Into Gap Between Ladder Frame And Bearing Cap
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.