>> D << Timing Chain TENSIONER Installation

WARNING: This page is about a different variant/trim than selected.

Install the timing chain tensioner on the cylinder block and tighten it to the specified torque.
Tightening torque: 10 ± 2 N.m (89 ± 17 in-lb)
Remove the hard wire (piano wire or the like) of ø1.5 or hexagonal bar wrench (1.5 mm [0.05 inch]) from the timing chain tensioner. This enables the plunger of the timing chain tensioner to push the tensioner lever to keep the timing chain tight.

Fig 1: Identifying Wire, Ratchet Release Hole And Plunger Fixed Hole
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.