Cylinder Head
WARNING: This page is about a different variant/trim than selected.
- Check the cylinder head for water leakage, gas leakage, damage or cracks before cleaning.
- Completely remove oil, scale, sealant, carbon, etc. After cleaning oil passages, blow air to make sure that they are not clogged.CAUTION: The grinding limit shall be within 0.2 mm (0.008 inch) in combination with the cylinder block to be assembled.
- For the flatness on the cylinder head bottom, measure distortion using a straight edge and free gauge. If the distortion exceeds the limit, grind and repair it.
Distortion on bottom
Standard value: Within 0.05 mm (0.002 inch)
Limit: 0.2 mm (0.008 inch)
Grinding limit: 0.2 mm (0.008 inch)
Cylinder head height
Standard value: 128.5 mm (5.06 inch)