LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Overhaul - 2.4L - Lancer) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> D << Crankshaft Bearing Lower Installation

>> D << Crankshaft Bearing Lower Installation

WARNING: This page is about a different variant/trim than selected.
  1. When replacing the crankshaft bearing lower, select a bearing with the size corresponding to the crankshaft journal diameter in the table below.
    Fig 1: Identifying Journal Identification Mark Position
    G05374372Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. The crankshaft bearing lower has an identification mark at the illustrated position.
    Crankshaft Crankshaft bearing
    Identification mark Journal diameter mm (in) Identification mark
    0 51.985 - 51.988 (2.04665 - 2.04677) 0
    1 51.982 - 51.985 (2.04653 - 2.04665) 1
    2 51.979 - 51.982 (2.04641 - 2.04653) 2
    3 51.976 - 51.979 (2.04629 - 2.04641) 3
    4 51.973 - 51.976 (2.04618 - 2.04629) 4
    Fig 2: Identifying Identification Mark On Crankshaft Bearing Lower
    G05425975Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install the selected crankshaft bearing lower.
scientia non olet · About LEMON Manuals