Section 85 (Engine Mechanical (Service Information L3))
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Mechanical Location Index
- Drive Belt Inspection
- Drive Belt Replacement
- Drive Belt Auto TENSIONER Inspection
- Plug Hole Plate Removal/Installation
- Before Repair Procedure
- After Repair Procedure
- Compression Inspection
- Valve Clearance Inspection
- Valve Clearance Adjustment
- Ignition Coil Removal/Installation
- High-Tension Lead Removal/Installation
- Ignition Coil Inspection
- Spark Plug Removal/Installation
- Timing Chain Removal/Installation
- Notes
- Crankshaft Pulley Lock Bolt Removal Note
- Chain TENSIONER Removal Note
- No.3 Engine Mount Rubber And No.3 Engine Joint Bracket Removal Note
- Engine Front Cover Removal Note
- Oil Pump Sprocket Removal Note
- Oil Pump Sprocket Installation Note
- Timing Chain Installation Note
- Engine Front Cover Installation Note
- Front Oil Seal Installation Note
- No.3 Engine Mount Rubber And No.3 Engine Joint Bracket Installation Note
- Crankshaft Pulley Lock Bolt Installation Note
- Cylinder Head Cover Installation Note
- Cylinder Head Gasket Replacement
- Front Oil Seal Replacement
- Rear Oil Seal Replacement
- Engine Removal/Installation
- Notes
- Plastic Fuel Hose Removal Note
- Plastic Fuel Hose Installation Note
- No.1 Engine Mount Rubber Removal Note
- No.4 Engine Mount Bracket And No.4 Engine Mount Rubber Removal Note
- No.3 Engine Joint Bracket Installation Note
- No.4 Engine Mount Bracket And No.4 Engine Mount Rubber Installation Note
- No.1 Engine Mount Bracket Installation Note
- No.1 Engine Mount Rubber Installation Note
- Engine Disassembly/Assembly
- Engine Tune-Up
- Variable Valve Timing Actuator Inspection
- Variable Valve Timing Actuator Removal/Installation
- Oil Control Valve (OCV) Removal/Installation
- Oil Control Valve (OCV) Inspection
- Torque Specifications