LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Mechanical (Service Information L3)) >> Ignition Coil Inspection >> Primary Coil Winding

Primary Coil Winding

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ignition coil connector.
  2. Measure the resistance between the following terminals using an ohmmeter:
    • A and B, B and C
      • If not as specified, replace the ignition coil.

    Specification 

    1. 0.49-0.57 ohms [20 °C {68 °F}] 

    Fig 1: Identifying Ignition Coil Connector Terminals
    G01930001Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals