LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Mechanical (Service Information L3)) >> Ignition Coil Inspection >> Secondary Coil Winding

Secondary Coil Winding

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ignition coil connector.
  2. Remove the ignition coil. (See IGNITION COIL REMOVAL/INSTALLATION .)
  3. Measure the resistance between the following using an ohmmeter.
    • Lead hole 1 to 4, 2 to 3
      • If not as specified, replace the ignition coil.

    Specification 

    1. 9.5-11.1 kilohms [20 °C {68 °F}] 

    Fig 1: Identifying Coil Lead Holes
    G01930002Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals