Section 270 (Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (2 Of 2))
WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Head Cleaning And Inspection
- Piston, Connecting Rod, and Bearing Cleaning and Inspection
- Crankshaft and Bearing Cleaning and Inspection (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Engine Block Cleaning and Inspection
- Service Prior to Assembly
- Piston and Connecting Rod Assemble
- Cylinder Head Assemble
- Intake Manifold Assemble
- Crankshaft and Bearing Installation
- Piston, Connecting Rod, and Bearing Installation
- Cylinder Head Installation
- Valve Lifter Installation
- Camshaft Installation
- Camshaft Cover Installation
- Ignition Coil Installation
- Engine Front Cover and Oil Pump Installation
- Oil Pan Installation
- Engine Oil Heater Installation
- Water Pump Installation
- Water Pump Pulley Installation
- Engine Oil Cooler Installation
- Engine Oil Cooler Housing Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Engine Coolant Thermostat Housing Installation
- Engine Coolant Thermostat Installation
- Exhaust Manifold Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Oil Level Indicator and Tube Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Intake Manifold Installation (1.8L LUW)
- Throttle Body Assembly Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Crankshaft Front Oil Seal Installation
- Timing Belt Rear Cover Installation
- Camshaft Position Actuator Adjuster Installation
- Camshaft Position Actuator Solenoid Valve Installation
- Crankshaft Sprocket Installation
- Timing Belt Idler Pulley Installation
- Timing Belt Tensioner Installation
- Timing Belt Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Timing Belt Lower Front Cover Installation
- Crankshaft Balancer Installation
- Timing Belt Center Front Cover Installation
- Timing Belt Upper Front Cover Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Drive Belt Installation
- Drive Belt Tensioner Installation
- Positive Crankcase Ventilation Pipe Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Engine Flywheel Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Automatic Transmission Flex Plate Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)
- Crankshaft Rear Oil Seal Installation
- Engine Block Assemble (1.6L LDE, LXV, 1.8L 2H0, and LUW)