Special Tools

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

EN-6351: Mounting Sleeves

For equivalent regional tools, refer to Special Tools .

Fig 1: Crankshaft And Crankshaft Front Oil Seal

Courtesy of GENERAL MOTORS CORP.

Clean the sealing surfaces.
Slide the EN-6351: sleeves (2) protective sleeve onto the crankshaft journal.
Slide the crankshaft front oil seal (1) over the protective sleeve on the crankshaft journal.

Fig 2: Crankshaft Drive Gear Bolt, Washer And Sleeves

Courtesy of GENERAL MOTORS CORP.

Remove the protective sleeve, and using the EN-6351: sleeves (3), press the seal ring into the pump housing.
Use the crankshaft drive gear bolt (1) and washer (2) to press in the crankshaft front oil seal.