Special Tools

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

EN-6009: Remover/Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

Fig 1: Ignition Coil Module And Special Tool

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil module (2) with the EN-6009: remover/installer (1).
Remove the EN-6009: remover/installer (1).

CAUTION: Refer to Fastener Caution

NOTE: Note the arrow on the cover.

Install the 2 ignition coil bolts an tighten to 8 N.m (71 lb in).

NOTE: Note the arrow on the cover.

Install the cover of the DIS ignition coil against the direction of the arrow.