LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 270 (Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (2 Of 2)) >> Engine Oil Cooler Housing Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)

Engine Oil Cooler Housing Installation (1.6L LDE, LXV, 1.8L 2H0, and LUW)

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the engine oil cooler housing to thermostat housing sealing surfaces.
  2. Install 2 NEW gaskets.
    3. Fig 1: Identifying Engine Oil Cooler Housing, Bolts And Engine Oil Cooler Inlet Pipe
    GM2026867Courtesy of GENERAL MOTORS CORP.
  3. Install the engine oil cooler inlet pipe (3).
  4. Install the engine oil cooler housing (1) and the 5 engine oil cooler bolts (2) and tighten to 25 N.m (18 lb ft).
    5. Fig 2: Identifying Engine Oil Cooler Outlet Pipe And Bolts
    GM2026830Courtesy of GENERAL MOTORS CORP.
  5. Install the thermostat housing coolant pipe (2) to the engine oil cooler housing.
  6. Install the 2 thermostat housing coolant pipe bolts (1) and tighten to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals