LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 270 (Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (2 Of 2)) >> Engine Coolant Thermostat Housing Installation

Engine Coolant Thermostat Housing Installation

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Engine Coolant Thermostat Housing Caution .
  1. Clean sealing surface.
  2. Install a NEW engine coolant thermostat housing seal.
    3. Fig 1: Engine Coolant Thermostat Housing
    GM2026832Courtesy of GENERAL MOTORS CORP.
  3. Install the engine coolant thermostat housing (2).
    4. CAUTION: Refer to Fastener Caution .
    NOTE: Screw in the 4 bolts until the engine coolant thermostat housing is in contact with the cylinder head.
  4. Install the 4 engine coolant thermostat housing bolts (3) and tighten to 2 N.m (18 lb in).
    5. Fig 2: Identifying Engine Coolant Thermostat Housing Bolts Tightening Sequence
    GM2028129Courtesy of GENERAL MOTORS CORP.
    CAUTION: Following the proper fastener tightening sequence and torque is essential. Failure to do so may fracture the thermostat housing.
  5. Tighten the 4 engine coolant thermostat housing bolts to 8 N.m (71 lb in) in sequence (1-2-3-4).
    6. Fig 3: Engine Coolant Thermostat Housing
    GM2026832Courtesy of GENERAL MOTORS CORP.
  6. Install the engine coolant thermostat housing retainer (1).
  7. Install the engine coolant thermostat housing retainer nut (4) and tighten to 6 N.m (53 lb in).
scientia non olet · About LEMON Manuals